Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Fairfield, CT

Extension Spring Replacement in Fairfield, CT

Side-mounted extension springs replaced in matched pairs, with safety cables installed. Typical cost $150-$350.

Extension Spring Replacement is one of the most common calls we get. A technician will explain what is wrong and what it will cost before starting, and test the door before leaving. Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

When to call for extension spring replacement

  • A stretched, sagging or snapped spring along one of the horizontal tracks
  • The door lifts unevenly or sits crooked
  • A missing or broken safety cable through the spring
  • Pulleys squealing or wobbling

Why this happens

  • Metal fatigue from years of stretching
  • Rust and worn pulleys
  • Mismatched springs from an earlier repair

What you can check yourself

  • Make sure each extension spring has a safety cable running through it. That cable keeps a snapped spring from flying across the garage.
  • Look at the pulleys and cables for fraying.
  • Don't try to stretch or re-hook an extension spring under tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Open the door fully and secure it so spring tension is released
  2. Replace both springs as a matched pair, color-coded for door weight
  3. Replace worn pulleys and lift cables if needed
  4. Install or replace the safety containment cables
  5. Balance the door and test it through several cycles

How much does extension spring replacement cost?

$150-$350Typical range, parts & labor
1-1.5 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Serving Fairfield, CT and nearby towns

The swing from hot, humid summers to freezing winters in Connecticut is hard on spring steel. Rust shortens spring life, and the first cold snap is when a worn spring tends to break.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Besides Fairfield (ZIP codes 06824, 06825 and 06828), we handle extension spring replacement in Bridgeport (4.7 mi), Westport (4.9 mi), Stratford (7.4 mi) and East Norwalk (7.4 mi). Call (833) 435-8883 to book a visit in Fairfield.

Extension Spring Replacement: frequently asked questions

How much does extension spring replacement cost in Fairfield, CT?

Extension Spring Replacement typically costs $150-$350 including parts and labor, and usually takes 1-1.5 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do extension spring replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is extension spring replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Connecticut or Fairfield requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Fairfield, CT

Allstar Opener Gear & Sprocket Replacement

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $125-$275

Garage Door Safety Inspection

A full safety check of springs, cables, sensors and auto-reverse.

Typical $75-$150

Wind-Rated Garage Doors

Hurricane-rated doors and reinforcement kits for high-wind and coastal areas.

Typical $1,800-$6,000

Garaga Garage Door Roller Replacement

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $150-$350

Sommer Opener Gear & Sprocket Replacement

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $125-$275

Overhead Door Garage Door Installation

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $1,200-$4,500

Ryobi Garage Door Opener Installation

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $350-$800

Chain Drive Opener Repair

Chain-drive openers repaired, re-tensioned or replaced.

Typical $125-$350

Carriage House Garage Doors

Carriage-style doors in steel, composite and wood, with decorative hardware.

Typical $2,000-$8,000

Marantec Opener Gear & Sprocket Replacement

Marantec is a German manufacturer of residential and commercial door openers.

Typical $125-$275

Wayne Dalton Garage Door Roller Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$350

LiftMaster Garage Door Sensor Repair

LiftMaster is the professional-installer brand of The Chamberlain Group. The color of the learn button on the motor unit shows which remotes are compatible (yellow on Security+ 2.0 models; purple, red, orange or green on older ones), and most current models work with the myQ app.

Typical $100-$250

Garage door stuck, noisy or broken?

Talk to a garage door technician in Fairfield, CT now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote